--- In DynoMotion@yahoogroups.com, Tom Kerekes wrote:
>
> Hi Tapio,
>
> We would need to see your settings and such, but one obvious thing would be if you don't have the X axis enabled in Mach3.
>
> HTH
> Regards
> TK
>
>
>
> ________________________________
> From: tapiolarikka
> To: DynoMotion@yahoogroups.com
> Sent: Monday, February 4, 2013 10:46 AM
> Subject: [DynoMotion] Re: Mach3 reset?
>
>
>  
>
>
> --- In DynoMotion@yahoogroups.com, Tom Kerekes wrote:
> Hi again!
>
> 1# The reset was due to missing E-Stop config as you guessed.
> The IO 46 (KFLOP LED)/active low fixed that.
>
> 2# I now get jogging w/ button in Mach3, but entering g0 x100 on
> MDI does not produce motion. Also executing program with
> "g0 x100" as only line does not produce motion.
>
> Any guesses what I have missed here? (I have 4.30j installed)
>
> Rgds,
> Tapio
>
>
> >
> > Hi Tapio,
> >  
> > What do you have the Mach3 EStop input configured as?  It is not possible to disable it.  You might set it to something that is always high like IO 46 (KFLOP LED) and set active low.
> >  
> > Regards
> > TK
> >
> >
> > ________________________________
> > From: tapiolarikka
> > To: DynoMotion@yahoogroups.com
> > Sent: Sunday, February 3, 2013 1:41 PM
> > Subject: [DynoMotion] Mach3 reset?
> >
> >  
> > Hi!
> >
> > I got my first axis tuned today so that following error is some 70 pulses on short as well as longer moves.
> >
> > I have a 2048 ppr encoder and I notice that to get full rotation I have to set movement to 8192, so apparently KFlop counts edges instead of pulses.
> >
> > I also got jogging with KMotionCNC but failed to get Mach3
> > running.
> >
> > PlugIn inits Kflop when I press reset but something is causing E-Stop
> > right after. I disabled everything I could in Mach config (limits,chargepump etc), but it didn't help.
> >
> > Has anyone got ideas/clues to the cause of this?
> >
> > Rgds
> > Tapio
> >
>